Store Submit a request
Sign in

Quick-Start Guide: Big Altitude Mode with Camera Controller

1. CHARGE IT UP Charge the Tag directly on the Base accessory port using the USB power cord provided. The charge light on the side of the Base will be red and will turn green once it’s fully charged. The Tag’s power LED will go from red to green when fully charged.

 

2. WARM THE TAG Power on the Tag and place outside with the top white side facing up for 8-10 minutes. LED1 should go from solid red to blinking red when ready for pairing.

 

3. MOUNT the BASE & CAMERA While the Tag is warming up, set up the Base on the ⅜” mounting screw and secure it with the wrench tool provided. Place your camera on top of the Base’s ¼” mounting screw and secure with the tightening wheel. 

 

4. POWER ON & SET UP CX405 CAMERA Go to the camera’s menu and select Camera/MIC>Focus>Auto. Then, Camera/MIC>SteadyShot>Active. Then, Camera/MIC>Digital Zoom>Off. Finally, Menu>Setup>PowerSave>Off. If you don't have the CX405, change these settings according to your camera's procedures. 

 

5. DOCK the CAMERA CONTROLLER and POWER ON BASE LED 1,2,3 will be illuminated when you have the Camera Controller docked. Plug your USB power into the Camera Controller’s bottom port, and then plug it into the camera. Plug your Multi (or AVR or 2.5 mm if you have a different camera) cable into the CC's top port, but not into the camera just yet. To change the Base's tracking and zoom settings, tap the power button until the LED you want to change is blinking, then tap the M button to cycle through the colors for each LED. Big Altitude is LED1 red.

 

6. CHOOSE CENTERING OBJECT The SOLOSHOT2 can track as close as 10-15 feet but for the set-up, choose a stationary centering object (trash can, tree, etc.) about 150-200 feet away from the Base. Your SOLOSHOT2 can be elevated from the area you’re filming but make sure you choose a centering object that is ground level with the area that your activity is taking place on. 

 

7. CENTER YOUR OBJECT Use your cameras LCD Screen and the arrows on the Base to aim the center of your camera’s viewfinder at the centering object you chose. Zoom your camera all the way in and place where the object meets the ground right in the center of the left-right play of the Base, as well as the center of the viewfinder.  

 

8. CONNECT MULTI TO CAMERA Plug in the multi (or AVR or 2.5 mm) cable to the camera gently so as not to disrupt your centering. The camera should zoom all the way back and the LED on the Camera Controller will illuminate green.

 

9. WALKABOUT and PAIR Your Tag should be warmed up by now, indicated by LED1 blinking red. Hold the Tag with top white side facing upwards in the palm of your hand and walk in a zig zag pattern within a 100 foot radius for 150-200 steps. The more, the better. End the walkabout at the Base, hold the Tag directly over the Base and immediately press both + buttons on the Tag and Base for a solid second or two to pair them. All LED’s on both the Base and the Tag will flash red when you release the + buttons. 


 
10. CALIBRATE Walk directly to your centering object, and push the + button on your Tag when you arrive at normal height level. LED3 on your Tag will blink red, and your Base’s green tracking LED will blink green at you, indicating that the camera is now recording and tracking. (To stop recording, hold the + button on the Tag for 2-3 seconds. LED3 on the Tag will blink green when camera is not recording.)

 

11. PUT ON ARMBAND and GO Snap Tag into armband clip and start your activity!

Have more questions? Submit a request

0 Comments

Article is closed for comments.